![]() ![]() ![]() Condensation from hot water produces mold and can shorten the life of light fixtures and bulbs, but the water will not condense if the fan takes the vapor out before it has a chance.Ĭonnecting your bathroom fan and light on the same switch is an effective way to avoid both. It just so happens that my old, leaky steam iron (which has been replaced now) uses the exact same size and type of wire that the pendant light does, so I decided to just use what I had.Operating the fan and lights on the same switch can solve several problems and prevent future difficulties, so you may want to do it even if your bathroom has two switches. You can purchase it at any home improvement store, but I found some wire in my house that I could use. The first thing you have to do is locate some replacement wire. If you’ve never rewired a light before, I promise you that it’s much easier than what you probably imagine in your mind. ![]() So it was just a matter of rewiring the pendant light, reinstalling it, and this time making sure I closed the chain link so that this couldn’t happen again. Fortunately, the circuit breaker did its job, sensed the surge of electricity, and cut off. That meant that every time I turned on that light switch, it was literally electrifying the metal junction box and probably the entire metal fixture for a split second, which was causing that surge of electricity that I was hearing. So as that light has been swinging in the wind, those wires have been rubbing against the metal piece inside the canopy, and it finally wore through the protective plastic on the wires. I probably bumped it with a ladder at some point over the last year, and didn’t realize that I knocked it off of the chain link. When I installed the light, I forgot to close the one chain link that I used to connect the light to the decorative canopy, and at some point over the last year, the light came off the chain link and was just hanging by the wires. I’ve been doing a bit of painting lately. Something had to be wrong with the way the light was wired.Įxcuse my primer-covered fingernails. That meant that the only other culprit could be the actual portico light. I shut the power off, disconnected the two light switches that controlled the fan and the portico light (which are in the same box by the portico door), rewired everything all over again, flipped the breaker on, tried the light switches again, and the same thing happened. So yesterday morning, I got up ready to troubleshoot. So I went to bed, but I could just imagine having to remove drywall, run new wires, etc. But it was already late at night, and I was exhausted, so I didn’t feel like that was the appropriate time to start troubleshooting my electrical problem. But then I flipped the switch for the portico light, and I literally heard a surge of electricity and then everything went dark. I flipped the switch for the ceiling fan, and it worked perfectly. I flipped the light switch for the ten downlights, and they worked perfectly. So I flipped the circuit breaker on and headed to the studio to test everything. So after all that time up and down the ladder, cutting the holes in the drywall bigger to fit the lights, and installing the lights, I thought everything was ready to go. I spent about three hours on Monday installing the thin downlights that I showed you yesterday, plus everything else on that circuit so that I could at least hook up that one circuit and have lights. But until I discovered the problem, I was kind of panicking. Fortunately I found the problem, and all I had to do was rewire a pendant light. What I didn’t share was the behind-the-scenes story about an electrical scare that made me lose sleep the night before last. ![]() Yesterday I showed y’all my brand new lighting in the studio. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |